PECO (439)

Provides the short burst of current required to operate the PL-11 and PL-10 series of Turnout Motors. The PL-31 Connectors are ideal for attaching the PL-34 Wiring Looms or PL-38 wire to these switches without soldering; the included Shrouds prevent current 'shorting out' between the terminals. PL-27 Switch Console Unit PL-28 Switch Mounting Plates PL-50 Turnout Switch Module

PECO LEVER OPERATED PASSING SWITCH

Lever Operated Passing Switch

Lever Operated Passing Switch Yellow

PECO has always been a forward-looking family company with a long tradition of innovative thinking. The business started trading in 1946 and is now in its third generation. Resistors for use with the PL-30 Red and Green LED's.

For use with all solenoid motors (e.g. PL-10 and Pl-11). Connect this unit to the 16v ac supply on your transformer. The capacitor stores up power and discharges a 'kick' to ensure turnout blades 'snap over' every time. PL-10 Turnout Motors PL-11 Surface Mounted Turnout Motors PL-38 Wire  

16/0.2mm 3 amp. Length 7m (approx 23ft)

The vital link. Your model railway will be so much easier to extend and maintain if you adopt a colour code scheme for the wiring. Specifications Length: 7m Recommended to be used with PL-39 Terminal Blocks PL-37 Self Adhesive Cable Clips PL-31 Spade Connectors  

16/0.2mm 3 amp. Length 7m (approx 23ft)

16/0.2mm 3 amp. Length 7m (approx 23ft)

16/0.2mm 3 amp. Length 7m (approx 23ft)

Invaluable wiring aid - no soldering required. Two strips of 12 blocks, easily cut into smaller units.

Wheel Cleaning Brush

Wheel Scraper

As easy as 1-2-3. Insert PL-26 switches into the slots of the PL-50 unit. PL-51 add on units can be easily added on the side. No soldering makes changes easy and safe for modellers of all ages.

And to extend your control panel-that's simple too! Simply slots into the side of the PL-50.

This new motor is suitable for all PECO turntables, so that includes the N, OO/HO, O-16.5 (On30), SM-32 and the HOm scale versions.This non-indexing motor (which means that there are no pre-set or programmable settings) means that the modeller can simply line up the deck against the exit or entrance road by eye, and the controls allow for small adjustments should things not align perfectly. This gives the modeller ultimate flexibility and control, and means that existing turntables on layouts can easily accommodate the new motor without any major track re-laying exercise! Power has to be provided from an independent 12vDC 2 amp supply, but other than that everything needed is included. Operating the motor is straightforward: you press and hold either of the clockwise or anti-clockwise buttons to rotate the deck and release the button when you wish to stop. Operation is extremely smooth. Retro-fitting the motor to an existing turntable in-situ is easy. The kit is supplied with three mounting fixtures that, when assembled, are glued to the underside of the turntable deck. There is also a special joining collar that links the motor to the central shaft of the turntable deck. Full instructions are included in the kit.